What properties are required when selecting injection molds and steel raw materials




What properties are required when selecting injection molds and steel raw materials


In the process of injection mold processing, the selection of raw materials will play an important role in the overall service life of the injection mold and the quality of the plastic products produced, so what performance requirements need to be met when selecting Jiangyin injection mold to process steel raw materials?

1. Good surface hardness and wear resistance

The hardness of the injection mold is usually below 50-60HRC, the surface hardness of the heat-treated mold is high, the mold in the work due to the injection molding filling and flow to withstand greater compressive stress and friction, the mold is required to maintain the accuracy of the shape and the stability of dimensional accuracy, increase the service life of the mold, the wear resistance of the mold depends on the chemical composition of the steel and the hardness of heat treatment, so strengthening the hardness of the mold can strengthen its wear resistance.

2. Good machinability

Most injection molds, in addition to EMD processing, also need to be cut and fitter repair, in order to increase the service life of cutting tools, strengthen cutting performance, injection molds to reduce surface roughness, injection mold steel hardness to be appropriate.

3. Good thermal stability

The shape of the parts of the injection mold is often more complex, it is difficult to process after quenching, so it should be selected as much as possible with good thermal stability, when the mold molding processing after heat treatment due to the small coefficient of linear expansion, heat treatment deformation is small, the temperature difference caused by the size change rate is small, the metallographic structure and mold size is stable, can be reduced or not processed.

4. Good polishing performance

The surface roughness value of the injection molding model cavity is required to be less than the level of Ra0.1~0.25, the optical surface is required to Ra<0.01nm, the cavity should be polished, reduce the surface roughness value, the steel selected for this purpose requires less material miscellaneous injection molding processing quality, fine and uniform structure, and there should be no pockmarks or orange peel defects during polishing.

As people have higher and higher requirements for plastic products, many requirements are put forward for the appearance, performance, cost and other aspects of products. Therefore, it is also necessary for injection molds to continuously adapt to the development of new technologies and make corresponding improvements on the original basis.

Navigation