What are the precautions for producing machined parts
For many large-scale equipment, machined parts are indispensable during production and assembly, and the quality of machined parts also determines whether the performance of the entire equipment can be fully released. At the same time, good machined parts can also extend the equipment. service life. There are also many factories on the market that produce machined parts. When producing machined parts, you should pay attention to the following matters in order to make better products.
1. Check the equipment and reinforce the parts of the equipment before production
The machined parts with good service must be carefully inspected before production to ensure the safety of the equipment; at the same time, the cutting tools and workpieces used by the equipment should be tightened with a wrench before machining the machined parts to ensure that during the production process The cutting is accurate and powerful without causing damage to the workpiece.
2. If the equipment is found to be noisy, it should be stopped and repaired
If the machined parts with good pre-sales service quality are found to be noisy during production, it may be that the gears have received certain damage. If the machined parts are not repaired in time, the machined parts will also be damaged. The correct repair method is generally to stop immediately and remove the burrs or other debris on the gears. If the gears are found to be damaged, the gears need to be replaced.
3. Ensure that the product is heated evenly during processing
The machined parts will go through the process of normalizing and roasting in the process of processing and production. Here, it is necessary to keep the temperature in the furnace uniform, and it must not be too large or too small, which will cause uneven heating of the machined parts and quality problems. . When the machined parts are cooled, be careful not to stack them together, but to cool them one by one.
During production of machined parts, it is mainly necessary to check the equipment to ensure the integrity and safety of the equipment, and then reinforced the parts for cutting to start using. The whole process is relatively simple, but if the production equipment of machined parts is found If there is abnormal noise, stop immediately and start inspection, otherwise it will affect the quality of the whole part. Strictly follow the procedures when heating and cooling the produced machined parts.